西門子PLC模塊廣州代理商

機床數據說明手輪連接的方式：

0 = SEGMENT_EMPTY ;無手輪
1 = SEGMENT_840D_HW ;連接840D X121
2 = SEGMENT_802DSL_HW ;連接到802Dsl
5 = SEGMENT_PROFIBUS ;連接Profibus模塊
7 = SEGMENT_ETHERNET ;通過以太網連接t

N11350 $MN_HANDWHEEL_SEGMENT[0] =1 1.連接到 X121
N11350 $MN_HANDWHEEL_SEGMENT[1] =1 2.連接到 X121
N11350 $MN_HANDWHEEL_SEGMENT[2] =5 3.連接到MCP 1的X60
N11350 $MN_HANDWHEEL_SEGMENT[3] =5 4.連接到MCP 1的X61
N11350 $MN_HANDWHEEL_SEGMENT[4] =5 5.連接到MCP 2的X60
N11350 $MN_HANDWHEEL_SEGMENT[5] =5 6.連接到MCP 2的X61

手輪參數 11351

配置手輪連接的硬件模塊.
(content of MD11350 $MN_HANDWHEEL_SEGMENT dependent):

$MN_HANDWHEEL_MODUL =

0 = 無手輪
1 ;840D硬件
1 ;802Dsl硬件
1..6 ;Prifibus/prifinet模塊的模塊號;
參數MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS[(x-1)]的索引號
1 ;以太網

N11351 $MN_HANDWHEEL_MODULE[0] =1 1st 手輪
N11351 $MN_HANDWHEEL_MODULE[1] =1 2nd 手輪
N11351 $MN_HANDWHEEL_MODULE[2] =3 3rd 手輪
N11351 $MN_HANDWHEEL_MODULE[3] =4 4th 手輪
N11351 $MN_HANDWHEEL_MODULE[4] =5 5th 手輪
N11351 $MN_HANDWHEEL_MODULE[5] =6 6th 手輪